This is the Cause of the Nyetrum PC Casing and How to Overcome It

Posted on

Have you ever felt the shock due to being touched on the CPU? Such cases occur quite often on computers using the CPU as the center. This is certainly very dangerous for users, especially if there are small children at home, the more dangerous if he plays around the computer that is on.

Surely you are very curious why we can get electrocuted just because it is touched on the chunk? To find out the answer, here are some causes.

Leaks in Power Supply
As we know that to run various kinds of computer components, it must be connected to a power supply. The function of power supply is to provide electrical power to computer components. With the power supply, the AC current is converted into a DC current.

Well, because the motherboard is directly connected to the power supply whose power is too large, it causes a leak which results in electrical power also flowing to the CPU section.

Bad Grounding System
Basically when an electronic device is installed, each cable has its own grounding system. This grounding system is a system for flowing excess electric current so that there is no shock effect on the user. However, the grounding system on computers in Indonesia often underestimates this.

Most computer grounding systems in Indonesia still do not pay much attention to safety. As a result, we can see computer cables always left milling about on the floor. Even though this is very dangerous because the cable is very likely to be trampled and or the electrical flow can spread to the floor.

Therefore, in order to prevent electrocution when touched, there are several ways you can do it.

1. Use the carpet in the computer room
When you first store a computer in the room, make sure that the room uses carpet. Apart from preventing the floor from getting wet, this method can also be a damper on the CPU part. So, when the computer is turned on, the electric current on the CPU body will flow to the carpet. That way, the CPU will not feel any electrical power.

2. Using footwear
If the computer room does not use carpet, then the next way is to use footwear when using a computer. By using footwear such as sandals, you will be safe from shock because of the poor cable grounding system.

3. Stream electricity to the wall
There are ways that can be an option for you to try, namely to drain electricity on the wall. For the ingredients themselves, prepare a nail that is approximately 10 to 12 cm long. After that, also prepare the electric cable for 1 meter.

For how to do this, first peel the end of the cord first. After that, tie the end of the cable to the back of the nail. It should be noted that the cable is fastened to the back of the nail and not to the part of the nail. After that, try the CPU casing on the floor or it can also be on the table so that the results can be more maximal. After that, the cable ties and nails are tied to the power supply bolt or the computer’s electrical parts. Finally, attach nails to the wall or floor.

4. Change Power Supply
One of the next effective ways is to replace the power supply. A leaky power supply is certainly very dangerous to the computer and its own users. Because, a leaky power supply is included in the sign of a damaged computer power supply.

 If the power supply is not replaced, some CPU components can be damaged. Therefore, you should buy a new power supply. Before you buy a new power supply, make sure you know what types of power supply is on the computer. In addition, you can also try tips on choosing a good power supply for PC Gaming. Because, PC gaming uses a variety of high components which of course the quality is no doubt.

5. Stick the CPU to the wall.
If you feel scared or lack courage with the earthquake points and third, then you can try the fifth method. This method is very easy because it only attaches the CPU to the wall. this is actually almost similar to the third point. Only, this method does not use intermediaries. In this way, the current flowing on the CPU can be forwarded to the wall so that we will not feel electrocuted when touching it.

That is the cause of the PC casing shocking and how to overcome it. You need to realize that when you feel electrocuted when touching a PC, then there is something wrong with the PC. Therefore, you must take action as soon as possible so that things don’t cool out.

If you feel uncomfortable with a PC, you can try switching to the laptop part. nowadays the ability of laptops can even match the capabilities of a PC. Plus, laptops are very practical to use. I hope this article can provide interesting information for you.

Gravatar Image
Devoted coffee specialist. Total internet scholar. Professional pop culture ninja.

Leave a Reply

Your email address will not be published. Required fields are marked *